Lancia Motor Club

Model Technical and Interest => Aprilia, Ardennes and Ardea => Topic started by: John Larkin on 21 August, 2020, 11:18:07 AM



Title: Aprilia doors opening angles
Post by: John Larkin on 21 August, 2020, 11:18:07 AM
What should be the total angular movement of the front and rear doors of a 1949 S2 Aprilia berlina from the closed position to fully open?  Mine do not seem to open as wide as some that I have seen while scouring photos on the internet.
Regards,
John Larkin.


Title: Re: Aprilia doors opening angles
Post by: simonandjuliet on 21 August, 2020, 02:03:05 PM
I will measure mine (47 S2 Berlina), however it may be easier to measure opening distances - my trig skills are a bit rusty , all I remember is SOH, CAH , TOA



Title: Re: Aprilia doors opening angles
Post by: Raahauge on 23 August, 2020, 05:22:48 PM
John.
I have today had to adjust one of our rear doors which was opening too far.
This gave me a chance to have a good look at the construction and it seems inevitable that opening angles will vary.
The stops are welded to the shell in what looks like a slightly random way, (none of mine are vertical). There is no provision for adjustment.
Because the sockets that the door balls sit in are able to rotate and move in and out to accommodate door fit, the point at which the finger will hit the stop will vary.
On none of my four doors do both top and bottom fingers hit both stops.
If the door fits the opening then I think the only adjustment would be welding a bit on (as I have had to do) or filing some off if you need more opening. Hope this helps.
Best wishes.


Title: Re: Aprilia doors opening angles
Post by: Dave Gee on 24 August, 2020, 08:24:54 AM

 John

    Door opening 1938(?)  Aprilia
    Taken outside just above the swage line
   
       Passenger side rear 138 deg   passenger front 128 deg

       Drivers side rear 126 deg  Drivers door 122 deg
     All doors are approx 2mm clear of the body when fully open.
Hope this is helpful.
   
     Dave


Title: Re: Aprilia doors opening angles
Post by: John Larkin on 26 August, 2020, 04:10:14 PM
Dear Dave,
Thank you for the measurements from your car.  Am I correctly interpreting the angles you gave in my attached sketch?  I hope the attachment works!
Regards,
John Larkin


Title: Re: Aprilia doors opening angles
Post by: John Larkin on 26 August, 2020, 04:13:25 PM
Hi Raahauge,
Information much appreciated!
Thank you.
Regards,
John Larkin.


Title: Re: Aprilia doors opening angles
Post by: Dave Gee on 26 August, 2020, 06:30:00 PM
 
  John
  That's correct.
Best wishes
Dave