|
Title: Fulvia Carburetor Drip Tray Post by: Beckerman67 on 13 December, 2022, 05:41:11 AM Can anyone advise me if the drain tube which attaches to the carburetor drip tray is fixed with a clip at any point along its length?
The manual suggests that it is, however, I don't know where I should be looking to attach the clip to? Title: Re: Fulvia Carburetor Drip Tray Post by: roddy on 16 December, 2022, 04:37:27 PM Yes, its is clipped just before its end, at the bell-housing. The piping then exits in the gap between the starter motor and crankcase. Hope of some help? Send me a PM if you want a photo to clarify.
Regards - Title: Re: Fulvia Carburetor Drip Tray Post by: lancialulu on 16 December, 2022, 05:24:45 PM There is also a metal p clip attached to the rear upper bolt of the oil filter housing holding the drain pipe tight inthe gap at the rear of the crank case.
|