Lancia Motor Club

Buy, Sell and Search => Spares required => Topic started by: zagatoman on 19 July, 2009, 04:43:26 PM



Title: Fulvia rubber bonnet bump stops
Post by: zagatoman on 19 July, 2009, 04:43:26 PM
Hi again all.

Another request you might be able to help with.

Looking for the rubber bonnet bump stops that are screwed on the body and help stabilizes the bonnet on a Lancia Fulvia, has two cone shaped ones in the back corners and two button ones at the front that are adjustable. Need all four but if you only have a couple, please get in touch.

Don’t forget, Still looking for the heater box for the engine compartment from a Series 1 Fulvia or Fulvia Zagato. Also good condition rear of-side (drivers side) bumper quarter for a series one Fulvia Zagato.

Thanks again, Paul


Title: Re: Fulvia rubber bonnet bump stops
Post by: fay66 on 19 July, 2009, 05:14:12 PM
Try Cavellitos,
I got four cone shaped ones for my 2c from them, admitted about 4-5 years ago, but certainly worth dropping him an email.

Brian
8227 8)


Title: Re: Fulvia rubber bonnet bump stops
Post by: St Volumex on 19 July, 2009, 06:31:43 PM
Hi Paul,

We just bought some rear bonnet stops (the cones) from Omicron at GBP1.79 each - much cheaper than anything w could get from Italy.

Kindest regards,


Title: Re: Fulvia rubber bonnet bump stops
Post by: zagatoman on 20 July, 2009, 11:58:30 AM
I contacted Omicron last week and they wanted to charge me £8 each for the bump stops, will have to ask them again, I probably misheard.

Still would like to hear from anyone that might have some knocking around.


Paul


Title: Re: Fulvia rubber bonnet bump stops
Post by: lancialulu on 20 July, 2009, 12:33:44 PM
Paul

On my series 2 sport there are only 2 at the rear somewhat square castle shaped.

I have checked my parts book and thats all they show.

What you describe are the coupe fixings (very familiar as I have them on my HF).

Has yours been modified? If so could you send me some photos and I might do the same.

On basis of photos i may have some spares??

Tim


Title: Re: Fulvia rubber bonnet bump stops
Post by: zagatoman on 06 August, 2009, 12:16:19 AM
Hi Tim

The Bump stops are for my series one Fulvia, not my Zagato, so any you have to fit a series 2 or 3 Fulvia will be fine.

Hope you are able to help,

Paul