Lancia Motor Club

Model Technical and Interest => Flavia => Topic started by: Parisien on 16 January, 2016, 08:43:55 AM



Title: Lancia Flavia Vignale for sale.....restoration .....something about this car....
Post by: Parisien on 16 January, 2016, 08:43:55 AM
http://www.ebay.co.uk/itm/1967-LANCIA-FLAVIA-CONVERTIBLE-NO-RESERVE-BARN-FIND-/161948520628?hash=item25b4e250b4:g:dx0AAOSwpRRWmYLW


Who was it on the forum who wanted kept occupied for the next few years.....nay, decade......:)


P


Title: Re: Lancia Flavia Vignale for sale.....restoration .....something about this car....
Post by: lancialulu on 16 January, 2016, 09:43:56 AM
They are popping out of the woodwork......


Title: Re: Lancia Flavia Vignale for sale.....restoration .....something about this car....
Post by: lancianut666 on 16 January, 2016, 01:21:32 PM
It looks to be well worth taking on if you are after a Vignale, would be a bit worried if any of the fuel injection bits are missing
Clarkey


Title: Re: Lancia Flavia Vignale for sale.....restoration .....something about this car....
Post by: ColinMarr on 16 January, 2016, 11:16:01 PM
All the complicated and tricky bits in the Kugelfischer fuel injection system are contained in the main pump, which is below the plenum chamber shown in one of the photos. If this unit is still full of oil and not mucked about with, it's probably not too difficult to get it back into good order. And a Flavia with Kugelfisher injection working as it should, is a delight to experience. as I remember from the not too distant past - see photo.

Colin


Title: Re: Lancia Flavia Vignale for sale.....restoration .....something about this car....
Post by: fay66 on 17 January, 2016, 12:14:05 AM
All the complicated and tricky bits in the Kugelfischer fuel injection system are contained in the main pump, which is below the plenum chamber shown in one of the photos. If this unit is still full of oil and not mucked about with, it's probably not too difficult to get it back into good order. And a Flavia with Kugelfisher injection working as it should, is a delight to experience. as I remember from the not too distant past - see photo.

Colin
Colin,
Obviously not taken in the UK ;)

Brian
8227 8)


Title: Re: Lancia Flavia Vignale for sale.....restoration .....something about this car....
Post by: lancialulu on 17 January, 2016, 08:01:33 AM
The number of RHD Vignales quoted (49), is that all types or just the KF (inezeone) model?


Title: Re: Lancia Flavia Vignale for sale.....restoration .....something about this car....
Post by: Sliding Pillar on 17 January, 2016, 08:28:19 AM
Total production of iniezione Flavia Vignale is quoted at 43 (tipo 814.434/435)
Not sure where the RHD figure comes from, but unlikely to be much more than 49 in total for all engine types.


Title: Re: Lancia Flavia Vignale for sale.....restoration .....something about this car....
Post by: lancianut666 on 17 January, 2016, 06:06:44 PM
with regard to the injection system I can't spot the fuel and air pipes, the injectors or the injector manifolds in the boot or the boxes, with my car the injector pump had oil in but the tricky bits inside had all seized so it was a specialist repair as the screws holding it together were unusual as I remember and I could not even disassemble it plus various special tools were quoted in the workshop manual I had. A guy in Nottingham who maintained BMW racers fixed it.
Clarkey