Appia Consortium News

[lancianut666]

What was not obvious when I started was that the aluminium drum had a lip holding the cast iron liner in place along with the pegs, my theory was that if I bashed half of the lip off when the liner was cut in half one half could be tappe out and the other knocked out as it had room to move. One snag was when the liner was cut through it pinched the jigsaw blade and nearly pulled my arm off as the blade was stuck but the jigsaw still went up and down! I will have to decide if it is a good use of my time splitting the front drums up...watch this space.
Clarkey

[lancianut666]

Hi all
My mate Terry and I managed to refine the process to just one cut through the drum and liner and with a bit of levering the liner comes out in one piece...result! time spent down to about 15 minutes. Problem is we burnt out the jigsaw.
Clarkey

[lancianut666]

Well we are getting near to scrapping the unloved S2 so get in touch if you need any parts it has a good set of  four 15" wheels, a working engine and gearbox, front seats, doors, bonnet, boot, grill, wiring loom, horn, bonnet and boot catches, petrol tank etc.
Clarkey

[Spider2]

Hi,
I need:
1/ Horn
2/ x 1 Headlamp chrome surround
3/ Interier roof lamp assembly
4/ Heater valve and cable
5/ Speedo cable
6/ Side panels (by drivers and passengers knees)
6/ Possibly wiring loom.
I have finished phase 1 of the recommisioning so the car is safe and driveable. Phase 2 will be the nice to do items so I am sure I will need a lot more in due course. Will all the bits be kept in storage?
Cheers
Simon

[lancianut666]

Hi Simon
All the parts are in storage now I just have to take the front axle off. I will check what we have on your list and get in touch. see pictures
Clarkey